You'll need>a raspberry pi 5 running Kali XFCE on SD card>a MT7921K w/ blutooth antenna setup and 2230 card, such as a Waveshare PCIe to M.2 E-KEY HAT+ (D)>Because the Pi 5 requires a specific 5V 5A USB-PD handshake over the USB-C CC pins to unlock f

Email
Subject
Comment
Verification	Please type the name of the object/variant:
File
Embed
Voice
Poll
Password	(For file deletion.)

Chud 11/15/26 (Sun) 03:22:03 №44978 [Quote]

You'll need
>a raspberry pi 5 running Kali XFCE on SD card
>a MT7921K w/ blutooth antenna setup and 2230 card, such as a Waveshare PCIe to M.2 E-KEY HAT+ (D)
>Because the Pi 5 requires a specific 5V 5A USB-PD handshake over the USB-C CC pins to unlock full peripheral current, standard car USB adapters cap it at 3A. A dedicated Pi 5 DC-to-PD buck module solves both voltage conversion and PD negotiation in one tiny board. So wire your LiFePO4 battery's XT60 (or Anderson Powerpole) lead through an inline fuse and rocker switch into a wide-input DC 9V–36V to 5.1V/5A Pi 5 PD Trigger Module (such as the Geekworm DC-DC 5V/5A step-down converter or SpotPear 5V5A PD module), then plug a short USB-C to USB-C cable straight into the Pi 5's power port.
>will need a cooling fan (use a Raspberry Pi 5 active cooler)
>add a 3D printed PETG plastic display case with slides to block/open the heat vents and block/open the antenna holes for your MediaTek network card
>add a MNT Reform cyberdeck keyboard + mouse

Now you're a fucking hacker!

Chud 11/15/26 (Sun) 03:24:20 №44980 [Quote]

>>44978 (OP)
Other than that, use a Raspberry Pi Touch Display 2, and use a Raspberry Pi Touch Display 2, and disable its capacitive touch layer in /boot/firmware/config.txt (disable_touch).